You’re missing the setup handshakes and termination tcp packets. The unfortunate thing is that this filter isn’t showing the whole picture. You’ll notice that all the packets in the list show HTTP for the protocol. To display packets using the HTTP protocol you can enter the following filter in the Display Filter Toolbar: http

is a good one because they have a very large site that loads a lot of information and (at the time of writing this) they have not switched to HTTPS, sadly. To start this analysis start your Wireshark capture and browse some HTTP sites (not HTTPS). Many people think the http filter is enough, but you end up missing the handshake and termination packets. There are some great Wireless traffic filters on wireshark website as well as on WiFi Ninjas Blog Wireshark filters.Filtering HTTP traffic in Wireshark is a fairly trivial task but it does require the use of a few different filters to get the whole picture. Wlan.fc.type_subtype = 0x04 & wlan_radio.signal_dbm < -75 Wlan.fc.type_subtype = 0x05 & wlan_radio.signal_dbm < -75 (wlan.fc.type_subtype=3)&(=55)ĭisplay Filters related Weak signals: wlan_radio.signal_dbm < -67 Wireshark Display Filters related 802.11 k,v,r traffic: 802.11 k,v,r Wireshark Display Filters related Retries: retry Wireshark Display Filters related Data frames traffic: data frames Wireshark Display Filters related Control frames traffic: control frames Wireshark display filters: management frames

Wireshark Display Filters related management traffic: It was shared as image file so I decided add different filters together and type here so people can just copy paste the filters instead having to type again themselves. These display filters are already been shared by clear to send .

Wireshark has two filtering languages: One used when capturing packets, and one used when displaying packets.

Wireshark display filter for udp packet